Glans Armor 2
The Glans Armor 2 is a "cage only" device, held in place by the hook of the PA piercing. If you don't have a PA piercing it won't work for you. Being locked by one's piercing makes it impossible to pull out of the cage without removing the PA Hook that holds it in place.
Device weight is important when considering options for a "tube only" or "cage only" Prince Albert chastity design, because a Prince Albert piercing may carry some of the devices weight. Heavy devices may cause a piercing to stretch or migrate, or even tear in a worst case scenario.
Our Glans Armor is a flyweight device that weighs approximately 1-1/2 ounces, all while still being made entirely of stainless steel!
You build your Glans Armor using the following parameters:
1) Cage Ring - The inner diameter of the cage ring will determine how much compression is experienced when you become aroused. In general, a ring diameter approximately 1/4" narrower than the width of the erect penis will create enough compression to remind one that arousal is forbidden.
2) Cage Length - The cage can be made any length you wish. It should not be made longer than one's flaccid penis length, however, otherwise a perpetual stretch will be placed on the piercing. If you wish to cover only your glans, then take a measurement from the tip of your penis to the back, top of your glans, perhaps adding 1/8" to that length.
3) Hook Diameter - Available pin sizes are 8 gauge, 6 gauge, 4 gauge, 2 gauge or 0 gauge.
4) Piercing Setback - Is the distance from your PA piercing to the tip of your penis. This measurement determines where the mount will be attached inside the cage. For 95-98% of men this measurement is normally between 3/8" and 1/2." This measurement should be taken without any jewelry in your piercing.
On March 25th, 2017 we changed the lock design of the Glans Armor from a disk style lock to a cylindrical lock. The new lock allows us to offer the hook in narrower gauges than the previous design permitted. The new cylindrical lock also makes installing the hook much easier than the old lock.
The hook may remain attached to the lock cylinder's during installation. Installation can be performed by swinging the hook into an open position, providing access for the hook to be inserted into the penis, prior to swinging the hook upward and forward, and through the front cage bars. The security screw is then tightened, locking the hook in place. Alternatively, the hook may be entirely detached from the cage for insertion into the piercing.
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: