The MouseTrap requires a Prince Albert piercing and is custom made to fit. The tube has a brushed finish and the hook is highly polished. The hook is locked to the tube via a high-security screw which utilizes a special key. The screw has a raised "pin" in it's socket and requires a special key having a "hole" in it's head in order to access the screw. A regular key won't access the slot in the screw.
You build your device using the following parameters:
1) Tube Length - The tube length is measured from the bottom, long edge of the device.
2) Tube Inner Diameter - The tube i.d. is chosen according to the size of your penis width when aroused.
3) Pin Diameter - Piercing gauge of your Prince Albert...available pin sizes are 4 ga, 2 ga. or 0 ga.
4) Piercing Setback - Is the distance from your PA piercing to the tip of your penis - this determines where the mounting hole for the hook will be located in the tube. For 95-98% of men this measurement is normally between 3/8" and 1/2." Rarely, but in some cases, the distance from the piercing to the tip of the penis may be between 5/8" and 3/4." This measurement should be taken without any jewelry in your piercing.
Tube Length: Your piercing will carry the weight of the device. A shorter tube will weigh less than a longer tube, and will therefore place less stress on your piercing.
A 2-3/4 inch long tube with a 1-1/2 inch inner diameter weighs 3 ounces. A narrower diameter tube will weigh a little less, whereas a longer tube will weigh more.
The 2-3/4" tube as measured from the bottom, long edge will have a top edge that is 1-1/2 inches long, entirely covering the glans and a bit of the shaft behind it.
A tube slightly longer than your flaccid penis will put a continuous stretch on your penis. A tube equal in length to you flaccid penis will cover the glans and entire shaft.
Tube Inner Diameter: The inner diameter of the tube will dicate whether the device is punishing, or whether it will be mildly compressive and only slightly uncomfortable when you become aroused. A good starting point is to take a measurement when erect, then determine the amount of compression accordingly.
Generally speaking, a tube 1/4" narrower than the width of his erect penis will create enough discomfort while permitting long term wear. Of course, pain tolerance varies among individuals, so use this suggestion only as a starting point to build your device.
Pin Diameter: Unfortunately, hooks smaller than 4 gauge are not offered because the diameter of the smallest security screw available is equal to the diameter of a 6 gauge hook. There's simply not enough material in the wall of the hook to support the screw!
Spare keys and screws are available in the Accessorize section.
A review of the MouseTrap may be seen at http://www.tpe.com/~altarboy/nt110719.htm
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: